Guides / Spares Cross-Reference

Solar Inverter & Agras UAV Spares Cross-Reference Guide (2026)

1. Solar inverter spares compatibility matrix

Utility-scale solar plants operating 1100V and 1500V string systems cannot afford weeks of downtime awaiting manufacturer lead times. The table below details verified interchangeability, original part numbers, and replacement protocols.

EquipmentComponentOEM markingCross-referenceNotes
Sungrow SG320HX / SG350HX / SG333HXMain power board (IGBT bridge base)P-B-001864P-B-001760_V3Same 1500V modular platform — same IGBT layout and mounting. Verify the board revision on the label (e.g. V3) against your fleet before ordering.
Sungrow SG110CX / SG136TXHigh-voltage IGBT moduleInfineon FF1000R17IE4PrimePACK 2 / Fuji 2MBI1000VXD-170EDirect drop-in. Requires fresh thermal compound (≥ 3.5 W/m·K) and torque-sequence tightening.
Huawei SUN2000-60KTL / 100KTL / 110KTLExternal cooling fanDelta THD0924HENMB-MAT 3615RL / Sanyo Denki 9GA0924P4G0324 V DC, 4-wire PWM, IP68. Keep the IP68 rating — lower-rated fans trigger ingress alarms.
Huawei SUN2000-330KTL-H1DC PV input terminal board setLabel P/N per unitSend nameplate photoOne set = left board PV1–14 + right board PV15–28. Socket layout must match the unit.
1500V DC combiner boxesDC PV fuse (10×38 / 14×51)Bussmann PV-1000A10HLittelfuse SPFJ / Mersen HP10MgPV certified, breaking capacity ≥ 30kA DC, fast-acting ceramic.

2. Agricultural UAV component matrix (DJI Agras)

PlatformSubsystemAftermarket optionBenchmarks
Agras T40 / T50Carbon folding propellersHigh-modulus carbon blades (5413 / 5415 form)Dynamic balance tolerance < 0.2 g; verify hub fit per batch.
Agras T40 / T50Centrifugal spray pumpIndustrial brushless magnetic-drive pumpZero-leakage magnetic drive; up to 16 L/min; CAN-bus feedback must match DJI ESC protocol to avoid "pump disconnected" faults.
Agras T30 / T20PDiaphragm spray pumpViton-diaphragm 12V/24V brushlessChemical-resistant Viton; flow consistency ±3% across 500 h.
Universal heavy-lift (EFT / TopXGun)Propulsion motorSunnysky V8318 / T-Motor P80 class14S–18S FOC; match ESC ecosystem; IPX7 washdown-rated options.

3. Where do genuine boards come from?

Top-tier inverter manufacturers sell complete units rather than loose boards, so genuine replacement boards on the open market originate from two legitimate channels:

  1. EPC project surplus — unused, factory-sealed spare modules purchased under multi-megawatt project contingency clauses, with purchase evidence.
  2. Serial-matched pull-out units (tested) — original boards pulled from working units, fully bench-tested; supplied only where the buyer explicitly accepts this condition in writing on the PI.

Every board we supply is label-photographed, serial-recorded, continuity and function tested on video before dispatch, and shipped in anti-static moisture-barrier packaging.

4. Export compliance red lines (agricultural UAV parts)

5. Recommended spare stock for a 50 MW plant

Based on field service experience, a practical starting point per 50 MW:

FAQ

Are Sungrow SG320HX, SG333HX and SG350HX power boards interchangeable?

Largely yes — same 1500V modular platform, and the core power board (P-B-001864, revision P-B-001760_V3) is cross-compatible. Always verify the board revision on the label against your fleet before ordering. Genuine isolated boards are rare at authorised distributors; typical sources are EPC surplus or serial-matched tested pull-outs (condition disclosed in writing).

Can third-party centrifugal pumps run on Agras T40/T50 without firmware errors?

Yes, provided the pump uses a brushless motor with CAN-bus feedback matching the DJI ESC protocol. Quality aftermarket centrifugal pumps (12–20 L/min, silicone-carbide seals) communicate with the flight controller without "motor overcurrent" or "pump disconnected" faults. We verify protocol compatibility per batch.

Why is cross-mating third-party MC4 connectors with original Stäubli PV-KBT4/KST4 dangerous?

Cross-mating connectors from different manufacturers violates IEC 62548. Microscopic differences in contact metallurgy, contact resistance and thermal expansion create hot spots at 1500V DC above 30A — arcing and fire risk. Use exact 1:1 original parts or fully matched plug-socket pairs; we supply both Stäubli original and TÜV-certified matched alternatives, never mixed.

What is the emergency dispatch lead time for critical boards?

Quotes within 24 hours of inquiry. Parts are sourced and video-tested, then dispatched from southern China; DHL/FedEx express reaches Tashkent, Almaty, Chișinău or Dubai in 4–7 working days after dispatch. Est. dispatch lead time: 3–8 working days after order confirmation, depending on part and channel.

Need a part cross-referenced?

Send a nameplate or board photo via WhatsApp (+86 134 6675 4325) or Telegram @APEXEXPORT — we reply with the exact part match and a quote within 24 hours.